Parts & Accessories

QALAM Pro Extruder

Standard part · DXC V1.1 dual-drive extruder

The dual-drive (twin-gear) direct extruder on the QALAM toolhead. Grips filament from both sides for consistent, slip-free feeding — from soft TPU to abrasive carbon-fibre blends.

QALAM Pro Hotend

Standard part · Creality K2 Plus hotend

The complete high-flow all-metal hotend assembly with a ceramic heater core, rated to 350 °C for engineering filaments. Includes heater block, heatbreak and nozzle carrier.

QALAM Pro Detachable Nozzles

Quick-change hardened nozzles for the QALAM hotend. Go smaller for fine detail or larger for faster, stronger prints. Sold per nozzle.

QALAM Pro Hotend Heater

The ceramic heater core for the QALAM hotend — the element that brings the nozzle up to temperature. A straightforward replacement if a heater ever fails.

QALAM Pro Hotend Thermistor

The temperature sensor that reads the hotend so Klipper can hold your set temperature precisely, print after print.

QALAM Pro Hotend Fan

Standard part · 3010 24 V axial fan

The 30 × 30 × 10 mm 24 V fan that keeps the heatbreak cool, so filament stays solid until it reaches the melt zone and never jams.

QALAM Pro Part-Cooling Fan

Standard part · 5015 24 V blower fan

The 50 × 15 mm 24 V blower that cools each freshly-laid layer for crisp overhangs, sharp corners and clean detail.

QALAM Pro Motherboard

Standard part · BTT SKR Pico or Mellow FLY DP5

The main control board that runs Klipper. Depending on production batch your machine ships with either a BTT SKR Pico or a Mellow FLY DP5 — both fully supported. Tell us your batch and we’ll match the right one.

QALAM Pro SBC Board

Standard part · BTT Pi V1.2.1

The single-board computer (BTT Pi V1.2.1) that runs the 3DISM touchscreen interface and talks to the mainboard over serial.

QALAM Pro Toolhead Board

The toolhead breakout PCB that consolidates the extruder motor, fans, heater, thermistor and strain gauge into a single cable back to the mainboard.

QALAM Pro Hotend Expansion Board

The expansion PCB at the hotend that fans the toolhead cable out to the heater, thermistor and cooling fans.

QALAM Pro Toolhead Cable

The flexible cable harness that carries power and signal from the mainboard to the moving toolhead — a common wear item on any CoreXY, easy to swap.

QALAM Pro Strain Gauge

The load-cell strain gauge behind the toolhead — the sensor that lets the printer probe the bed by touch for automatic Z-offset and mesh levelling.

QALAM Pro XY Stepper Motors

The two motors that drive the CoreXY motion — one for the X path, one for the Y. Sold individually.

QALAM Pro Z Stepper Motor

The lead-screw Z-axis motor that raises and lowers the bed, layer by layer.

QALAM Pro X-Axis Bearing

Standard part · MGN12C linear rail carriage

The MGN12C linear rail and carriage that guides the toolhead across the X axis — smooth, backlash-free motion that holds its accuracy over time.

QALAM Pro XY-Axis Belts

The CoreXY drive belts. A periodic wear item — fresh belts keep dimensional accuracy tight and motion quiet.

QALAM Pro Z-Axis Closed-Loop Belt

The continuous closed-loop belt that drives the Z axis.

QALAM Pro PEI Spring Steel Sheet

Powder-coated PEI flexible spring-steel build plate — textured grip that holds prints down while hot, then releases them with a flex. Two sizes, one per machine.